5 min read · Updated 30 September 2026
Driveway Sealing: Is It Worth It?
What a sealer does and does not do, why cleaning first matters most, and which drives benefit.
The short answer
Sealing is worth it for block paving that has just been deep cleaned, because it locks the jointing sand in place, slows weed and moss growth and makes oil and tyre marks easier to clean off. It also refreshes faded colour. It is not a repair: a sunken, cracked or badly laid drive needs fixing first.
For tarmac, a sealer or restorer can revive a tired grey surface, but it will not cure potholes or failing edges.
What a sealer actually does
A sealer soaks into the surface of the blocks and the joints and cures to a protective film. Joint stabilising sealers harden the kiln dried sand so it does not wash out or get sucked up by pressure washing. Finish options range from a natural matt look to a wet look sheen that deepens colours.
How the job is done
First comes a thorough clean: pressure washing to remove dirt, moss and weeds, often with a treatment to kill spores. The drive then needs to dry. Fresh kiln dried sand is brushed into the joints, and the sealer is applied in suitable weather, dry and not too cold.
The drive is usually kept clear of cars while the sealer cures. Rushing the drying stage is the most common reason a sealer turns cloudy or white.
How long it lasts
Sealers wear gradually with traffic and weather. Most installers suggest reapplying every few years, depending on the product, how busy the drive is and how shaded it is. Busy turning areas wear first.
When not to seal
Do not seal over moss or dirt, over damp paving, or on a drive with loose or rocking blocks. Natural stone and resin surfaces need their own specific products. If your paving has sunk, see our sunken block paving page first, because sealing will only preserve the problem.
If you mainly want a cleaner drive, a professional clean on its own may be enough. Our driveway cleaning service can advise on whether sealing adds value for your surface.
Keeping a sealed drive looking good
Once the sealer has cured, regular light care keeps it looking fresh. Sweep off leaves before they stain, especially from oak and sycamore trees, and rinse the drive with a garden hose rather than a high pressure lance, which can wear the finish and loosen joints. Spot treat any weeds that appear in joints before they establish. Deal with spills promptly. Engine oil and fuel should be blotted with absorbent granules or cat litter rather than spread with water. Rust marks from garden furniture and fertiliser pellets are easier to lift on sealed paving, but still best removed quickly. Every so often, check the busiest turning areas: if water no longer beads on the surface there, the sealer is wearing thin and a top up coat may be due. Keeping skips, scaffolding and heavy vans off the drive where possible will also prolong both the sealer and the paving underneath it for longer.
Frequently asked questions
- Is sealing block paving worth it?
- It is usually worthwhile after a deep clean, as it stabilises the jointing sand, slows weeds and makes stains easier to remove.
- How long does driveway sealer last?
- It depends on the product and how much traffic the drive gets, but most installers suggest reapplying every few years.
- Can I drive on my drive after sealing?
- Not straight away. Cars should stay off until the sealer has cured, and your installer will tell you when it is safe.
- Why has my sealed drive gone white?
- Whitening or clouding usually means the sealer was applied to paving that was still damp, or rain arrived before it cured.